Gravedigger Broadheads Review | The Inside Information

In this review, I’m going to be covering a broadhead that has been around for a while. It’s one I’ve actually used in the field quite a bit and been fairly successful with. It’s called the Gravedigger.

The Gravedigger Hybrid broadhead overview

Let’s take a look at the design and some of the features of the Gravedigger Hybrid head (it’s called a “hybrid” because it has both fixed and mechanical blades). Then, I’ll show you how it performed when I put it through my standard array of tests.

The cutting diameter of the Gravedigger Hybrid’s fixed blades is 1 inch. In the closed position, the mechanical blades are ½-inch. So, just in the closed position, if the blades were not to open at all, it would be an inch and 1/2 of a cut, which is no slouch of a cut.

But the mechanical blades do open. They open really well, in fact. They’re not held in place by an O-ring or a retention clip, but rather just by friction, and that’s adjustable with a small Allen bolt.

Gravedigger Blade specs

The blades of the Gravedigger are made out of a 416 stainless steel. The ferrule is a 7075 aluminum. It’s a pretty vented blade, but it’s still is a good stout aluminum, and the tip is a hardened steel, really stout, chisel tip.

I couldn’t find any information listing the blade thickness, so I used my micrometer to measure. The fixed blade measured 0.039 inches thick and the mechanical blades were 0.032 inches thick.

Gravedigger broadheads testing

I was eager to see how this head performed in my tests. I did not test it for long range flight, because I know it flies really well.

I consider it like a mechanical in terms of flight in the closed position, and I don’t test mechanicals for long range flight, because they all fly really well, even though this head has the little one inch fixed blade. I know it flies fantastic.

I tested for edge sharpness and retention, for penetration, and for durability.

Let’s see how the Gravedigger performed.

#ad

Sharpness Test

The Gravedigger cut paper after four strokes of the arrow.

Ballistic Gel Penetration Test

The Gravedigger penetrated 6 and 1/4 inches through the foam and ballistic gel.

MDF penetration test

I shot the Gravedigger through MDF five times. Below are the pictures.

I shot the first one in the closed position and the baldes didn’t open very much. But, then on the following shots, I kept the head in the open position when I was shooting, just to test durability.

Final Thoughts

So, what do you think of the Gravedigger?

Going through these tests reminded me why I liked it so much when I first started using it way back.

There are just so many heads. It’s hard to keep using just one. I’m a broadhead junkie and like to keep trying new things!

But, this is definitely a broadhead that’s worth a look. There are some weaknesses to it but there are a lot of strengths to it as well.

So, check out the score sheet below and see what you think about it, and decide if these broadheads are the right heads for you.